This document provides instructions for replacing a water heater. It outlines disconnecting the old water heater by turning off the gas and water valves and disconnecting lines. It then instructs to place the new water heater, hook up the water and gas lines, turn on the gas, light the pilot, and switch it to the desired temperature setting. It emphasizes ensuring teflon tape is used on the threads to prevent leaks.
5. Valve controlling water from source.
Close this by turning clockwise until it
stops. Call an Artilleryman to make
sure it’s tight
6. Hot water out
to house
Disconnect
this second.
Cold water in from source
Disconnect this after closing
valve shown on previous slide.
Cold water in from
source Disconnect
this last
13. Main gas valve to the W.H. (Turn
clockwise until it doesn’t turn any
more. If you cannot turn it, call a friend
who is either active duty or Retired
ARTILLERY to turn it for you.
14. Remove this from the fitting, you may
have to disconnect the line further
down the chain before doing this.
15. 1. Pull that old piece of shit water heater (W.H.) out
now and throw it into the street like a punk biotch.
2. Place your new, sexy, water heater in place
3. 3. Hook up the water lines first and foremost
4. Hook up the gas line
5. Turn on the gas line
6. Light the pilot
7. Switch to “Hot” or whichever girly setting you like.
8. Netflix
9. Chill
16. Make SURE you put Teflon
thread tap on the damn
threads (unlike the “licensed
Plumber that did this job
previously), if not your shit will
leak. I Promise.
17. Make SURE you put Teflon thread
tap on the damn threads (unlike
the “licensed Plumber that did
this job previously), if not your
shit will leak. I Promise.