Black boxes, also known as flight data recorders (FDR) and cockpit voice recorders (CVR), are devices installed in aircraft to record technical data and ambient sounds in the cockpit. FDRs record flight parameters like airspeed, altitude, and instrument readings, while CVRs contain audio recordings from microphones in the pilots' headsets and cockpit. Investigators rely on data from black boxes to determine the cause of plane crashes when they occur.
1 of 3
Download to read offline
More Related Content
Black
1. Black-Box
Abstract of Black-Box
As the technology progressing, the speed of traveling is also increased. The source to
destination became so closer to each others. The main advancement in the field of the
air traveling system with the help of airplane. This is the major discovery of
technology. But as the speed increases , the horror of air crash also introduced.
Because at a height of 2000m and above if a plane crashes ,it will be a terror for any
body. So to take the feed back of the various activities happens in the plane and record
them engineers need a mechanism to record such activities .
With any airplane crash, there are many unanswered questions as to what brought the
plane down. Investigators turn to the airplane's flight data recorder (FDR) and cockpit
voice recorder (CVR), also known as "black boxes," for answers. In Flight 261, the
FDR contained 48 parameters of flight data, and the CVR recorded a little more than
30 minutes of conversation and other audible cockpit noises.
Introduction of Black-Box
In almost every commercial aircraft, there are several microphones built into the
cockpit to track the conversations of the flight crew. These microphones are also
designed to track any ambient noise in the cockpit, such as switches being thrown or
any knocks or thuds. There may be up to four microphones in the plane's cockpit, each
connected to the cockpit voice recorder (CVR).
2. Any sounds in the cockpit are picked up by these microphones and sent to the CVR,
where the recordings are digitized and stored. There is also another device in the
cockpit, called the associated control unit , that provides pre-amplification for audio
going to the CVR.
Here are the positions of the four microphones:
Pilot's headset
Co-pilot's headset
Headset of a third crew member (if there is a third crew member)
Near the center of the cockpit, where it can pick up audio alerts and other
sounds
Most magnetic-tape CVRs store the last 30 minutes of sound. They use a continuous
loop of tape that completes a cycle every 30 minutes. As new material is recorded, the
oldest material is replaced. CVRs that used solid-state storage can record two hours of
audio. Similar to the magnetic-tape recorders, solid-state recorders also record over
old material.
Flight Data Recorders :
3. The flight data recorder (FDR) is designed to record the operating data from the
plane's systems. There are sensors that are wired from various areas on the plane to
the flight-data acquisition unit, which is wired to the FDR. When a switch is turned on
or off, that operation is recorded by the FDR.
In the United States , the Federal Aviation Administration (FAA) requires that
commercial airlines record a minimum of 11 to 29 parameters, depending on the size
of the aircraft. Magnetic-tape recorders have the potential to record up to 100
parameters. Solid-state FDRs can record more than 700 parameters. On July 17, 1997
, the FAA issued a Code of Federal Regulations that requires the recording of at least
88 parameters on aircraft manufactured after August 19, 2002 .
Here are a few of the parameters recorded by most FDRs:
Time
Pressure altitude
Airspeed
Vertical acceleration
Magnetic heading
Control-column position
Rudder-pedal position
Control-wheel position
Horizontal stabilizer
Fuel flow
Solid-state recorders can track more parameters than magnetic tape because they
allow for a faster data flow. Solid-state FDRs can store up to 25 hours of flight data.
Each additional parameter that is recorded by the FDR gives investigators one