CIM
- 3. 1. Check that the main power to the CIM is switched on. 2. Check that the circuit breakers in the CIM fuse box are switched on. 3. Check that compressed air available. 4. Remove all the pallets from the wagons.
- 4. 5. Remove all pallets from the storage tower. 6. Check that at the Pneumatics Station (PN-2800) is ready to load the raw materials. 7. Remove lens cap from the Vision Robot. 8. Check that there are no cylinders in the loading chute. 9. Check that there are no pallets on the loading area.
- 5. Verify that each of the workstations to be used during the process are lit and the correct switches in each element are activated . Check the bulbs of each season.
- 8. This section describe how to Set the stations to operate under Control by running VuRun CIM. From here you control all processes involved using software that is connected to each of the workstations.
- 10. Wagons are stored in this station for use in subsequent processes
- 12. To transport the wagon or the workpiece to be machined to the winch must be a person in charge of that, because it does not have a mechanical arm.
- 14. The movement of the robot arm can be controlled by a software executable programs, or manually by a control. In the process the robotic arm is used to move cars in the cab of the router.
- 17. At this station quality control of the finished part it is performed, images are taken to determine if it meets the required parameters.
- 20. Presence sensor
- 21. Presence sensor
- 22. Position sensors
- 24. Density sensor
- 26. Pneumatic sensor
- 27. Limit sensor
- 28. Proximity sensor
- 29. Hydraulic sensor
- 32. Probe sensor