�ݺ�ߣ

COLD CAUSTIC NANOCOATING
COPPER WIRE

2.1 Gather Materials wire stripper, vinyl
gloves, safety goggles, coca cola bottle, cold
caustic liquid, 14 awg wire or smaller

Have a spray bottle of vinegar for safety. If caustic
gets on your skin spray vinegar on the area

Purchase bare copper wire will
make the job easier. Size 14 awg
wire or smaller

If you can only locate coated wire, The Klein Tools -
Katapult Wire Stripper/Cutter will
make this task MUCH easier

2.2 Measure approximately 4 inches
of wire and cut

coldcausticsolid-150804011231-lva1-app6891.ppt

2.5 Use pliers to bend the end of
the wire back towards itself

Notice that the end of the wire is NOT
touching itself

2.6 Bend the bottom wire in the
opposite direction

Notice the edge of the wire is
directly pointing back at the body of the wire.
The edge cannot be seen from behind.

2.7 Repeat for all of the wires

2.9 Open your Coca Cola bottle

2.10 Place your wire in the Coca
Cola bottle

2.12 Shake up the contents of the
cold caustic liquid

2.13 Check the sprayer nozzle to
verify it is open

2.14 Spray several times into the
bottle

2.15 Replace cap onto the bottle

2.16 Shake the bottle to allow liquid
to coat the copper

2.17 Carefully pour the excess liquid
back into the sprayer bottle

2.18 Replace Cap and shake bottle

2.19 Rest bottle at an angle to allow excess
liquid to collect away from the copper

2.20 Note the time. Wait 6 hours

2.21 Shake the bottle
2.22 Pour off excess liquid back into spray bottle
2.23 Set bottle down at an angle

2.24 Let the bottle sit overnight

2.26 Set Nano Coated Wires out on a towel to
dry. Always use Gloves When Handling
NanoMaterials

2.27 Pour any remaining liquid into
the spray bottle

2.28 Label Your Coca Cola Bottle
For safety and reuse

coldcausticsolid-150804011231-lva1-app6891.ppt