�ݺ�ߣ

NASDAQ: ERII
��Ա��ǲԲ��ܳ��پ��ǲ� and Desalination
May 07, 2020
Juan Miguel Pinto, Energy Recovery Inc.

Confidential & Proprietary
AGENDA
1. Introduction
2. Desalination
3. SWRO – Seawater Reverse Osmosis
4. Energy consumption
5. Renewable energy
6. Conclusion
2

INTRODUCTION
4
Source: https://www.wri.org/aqueduct

INTRODUCTION
5
The Impact of Water Scarcity on GDP
Today’s Path A Better Path
Source: https://www.worldbank.org/en/topic/water/publication/high‐and‐dry‐climate‐change‐water‐and‐the‐economy

DESALINATION
7

DESALINATION
8
1970 1982 2002 2005
Multistage Flash Membrane
Technology
Membrane
Technology
Improvements
Renewable Energies
Source: Multistage picture ‐ Environmental XPRT. Membrane technology ‐ James Grellier / Wikimedia Commons

DESALINATION
9
Seawater Reverse Osmosis Cost Trend
Source: Watereuse association – Seawater Desalination Costs 2020 – Estimated cost breakdown.
Jubail SWRO – 0.41 USD/m3 and Yanbu 4 – 0.47 USD/m3

DESALINATION
10
Membrane Feed Pressure for Feedwater and Membrane Technology
80
70
60
50
40
10
20
30
Bar
RO
Sea Water
RO
Brackish water
RO
Low pressure
NF
Nano‐
filtration
UF
Ultra‐filtration
MF
Micro‐
filtration

DESALINATION
11
Annual Contracted Capacity by Feedwater Type, 2000‐2019
Seawater is feedwater with higher contracted capacity
Dotted line indicates values through June 2019; Source: GWI

DESALINATION
12
Annual Contracted Capacity by Region, 2000‐2019
Persian Gulf has the largest demand of SWRO desalination

DESALINATION
13
Additional Contracted Desalination Capacity by Technology, 2000‐2019
Reverse Osmosis as preferred technology for SWRO desalination

SWRO –
Seawater
Reverse Osmosis

SWRO DESALINATION PROCESS OVERVIEW
15

SWRO DESALINATION PROCESS OVERVIEW
16
Source: www.Sciencedirect.com

��Ա��ǲԲ��ܳ��پ��ǲ�

ENERGY CONSUMPTION FOR SWRO
18
0
5
10
15
20
25
1970 1975 1980 1985 1990 1995 2000 2005 2010 2015 2020
Specific
energy
consumption
(kWh/m3)
Energy consumption over time
Multistage
Flash
Evaporation
Multistage
Flash
Evaporation
Reverse Osmosis
Francis
Turbine
Pelton
Turbine Isobaric
��Ա��ǲԲ��ܳ��پ��ǲ� Over Time

RO Process 2 kWh/m3
Intake 0.45 kWh/m3
Pre‐Filtration 0.24
kWh/m3
Permeate Treatment
0.4 kWh/m3
Permeate Distribution
0.22 kWh/m3
2.98 kWh/m3
Energy consumption
in SWRO
o RO Process is the most energy intensive
process within the SWRO treatment plant
o ERD can reduce energy consumption of RO
process up to 60%; therefore, it is a critical
component to achieving 2 kWh/m3
o ERD CAPEX only represents 1% of overall
plant CAPEX
19
��Ա��ǲԲ��ܳ��پ��ǲ� per Process
Permeate distribution
0.22 kWh/m3
Intake
0.45 kWh/m3
RO process
2 KWh/m3
Permeate treatment
0.4 kWh/m3
Pre‐Filtration
0.24 kWh/m3
Source: www.Sciencedirect.com

A full‐size main high‐pressure pump is use to supply the membranes with 100% of the feed flow +
pressure in order to over come the osmotic pressure of the membranes. Potential energy is
“wasted” across the discharge valve.
20
How it Works
HP Pump Provides Full Feed Flow and Pressure to SWRO Membranes
Problem Statements:
o Energy consumption and costs made SWRO uneconomical historically
o Approx. 60% of energy wasted during SWRO prior to implementation of ERDs
SEC: 8 kwh/m3

The Pelton Wheel converts hydraulic energy into mechanical energy to offload the work done by
the high‐pressure pump’s motor. The Pelton Wheel’s shaft is directly connected to a dual‐shafted
motor and must rotate at the pump’s design speed. The high‐pressure pump must be sized for the
full flow and head required by the membranes.
21
How it Works
Pelton Wheel
SEC: 4 kwh/m3

Turbochargers convert hydraulic energy in the brine stream into mechanical energy reducing the
amount of head required by the main high‐pressure pump. The turbine drives the pump section
“boosting” the discharge of the high‐pressure pump to membrane feed pressure. The Turbocharger
“decouples” the ERD from the pump and motor, allowing it to run at higher speeds and higher
efficiency than the Pelton Wheel.
22
How it Works
Turbocharger
SEC: 3.6 kwh/m3

The PX Pressure Exchanger converts hydraulic energy in the concentrated brine stream into
hydraulic energy that supplements the flow from the main high‐pressure feed pump which feeds
the membranes. This is done via direct contact between the concentrated brine and filtered
seawater feed stream.
23
How it Works
PX
SEC: 2.98 kwh/m3

0
20
40
60
80
100
Percent Efficiency
ERD Efficiencies
24
Isobaric energy recovery systems have high efficiency regardless of system size
Isobaric
Turbocharger
Pelton Turbine
Increasing Flow

o Carlsbad SWRO
 Location: California
 Capacity: 189,250 m3/day (50 MGD)
 Energy recovery device: Isobaric – PX devices
 116 million kWh (kilowatt‐hours)
 Equivalent to 82,107 metrics tons per year of CO2
 Equivalent to 12 million dollar in electricity cost
25
https://www.epa.gov/energy/greenhouse‐gas‐equivalencies‐calculator
Photo courtesy of Poseidon Water

��Ա�ɲ��Ա��

RENEWABLE ENERGY POWERED DESALINATION
o The energy consumption of seawater desalination is higher than traditional water supply
solutions (groundwater, rain catchment, rivers, lakes, etc.)
o This is a sustainable and cost effective solution thanks to decreasing cost of renewable
energy systems
o Baseline scenario assumes
compounded growth rate
of water desalination of
10% per year
o Target scenario assumes
gradual introduction of
fully renewable powered
desalination until 2040
27
Estimated CO2 Emissions of Global Water Desalination Plants
Source: Global Clean Water Desalination Alliance

o Suitable option for remote locations
and small islands where the reliable
and safe provision of drinking water
is a constraint and expensive
o Electric grid and water networks are
often inadequate
o Small‐scale renewable energy
powered desalination can be the
optimal solution to address the
water constraints
SMALL‐SCALE RENEWABLE ENERGY POWERED DESALINATION
28

TECHNOLOGY BRIEF: SMALL SCALE SOLAR SEAWATER DESALINATION –
DIRECT COUPLING (OFF‐GRID), NO STORAGE
o This configuration is ideally suited for very remote locations with limited access to a reliable
electricity grid and service personnel
o The configuration avoids using batteries and uses water storage instead to allow a water supply
during day and night
29
Daily Water Production

o Good option for locations with inadequate grid supply but access to service personnel for
batteries or back‐up generators
o Distributed solution obviating the need for costly water transmission and distribution systems
TECHNOLOGY BRIEF: SMALL SCALE SOLAR SEAWATER DESALINATION –
DIRECT COUPLING (OFF‐GRID) WITH STORAGE OR BACKUP GENERATION
30
Energy supply system
o Photovoltaic modules/Wind turbine
o Batteries storage
o Back‐up diesel

o Good option for locations with access to a reliable electric grid
o The renewable energy supply system can be sized to completely offset the CO2 emissions of the
desalination plant
o Reduced maintenance requirements due to absence of storage and backup generators
TECHNOLOGY BRIEF: SMALL SCALE SOLAR SEAWATER DESALINATION – GRID CONNECTED
31

o The Desalination Plant and the Renewable Power Plant are connected to the grid and don’t need
to be co‐located
o The Renewable Power Plant is sized to completely offset the CO2 emissions of the Desalination
Plant (over the lifetime of the plant)
TECHNOLOGY BRIEF: UTILITY‐SCALE RENEWABLE DESALINATION –
GRID CONNECTED WITH VIRTUAL NET METERING
32
Desalination Plant Electricity Grid Renewable Power Plant
o Operates 24h per day
o Connected to the grid,
using existing
infrastructure to supply
electricity 24h per day
o Operates only during certain hours of
the day producing electricity from
sunlight or wind
o Connected to the grid, using existing
infrastructure

Item Description
Owner/promoter
Elemental Water
Makers
Location of
SWRO Plant
La Union, Luzon,
Philippines
Year of construction 2018
Capacity of
SWRO Plant
11 m3/d
Type of RE Plant PV plant
Capacity of RE Plant 4 kWp
REFERENCES: SMALL‐SCALE SOLAR DESALINATION (OFF‐GRID) – PHILIPPINES
33
General Information
11 m3/d PV powered RO system from Elemental
Water Makers, Philippines
Source: https://www.elementalwatermakers.com/project‐philippines/

Item Description
Owner/promoter Dafeng Plant
Location of
SWRO Plant
Jiangsu province,
China
Capacity of
SWRO Plant
5,000 m3/d
Type of RE Plant Wind power
Capacity of RE Plant 2.5 MW turbine
REFERENCES: MEDIUM‐SCALE WIND AND SOLAR‐POWERED DESALINATION – CHINA
34
An independent grid was designed to support the desalination of 10,000 m3/day of sea water a day.
The current production line has a capacity of 5,000 m3/day.
Containerized system
Source: http://en.fhned.com/product/equipments/

Item Description
Owner/promoter Water Corporation
Location of
SWRO Plant
Kwinana, Perth
Western Australia
Capacity of
SWRO Plant
144,000 m3/d
TDS (design) 35,000 – 37,000 mg/l
Specific Energy
Consumption
4 ‐ 6 kWh/m3
Power requirement
of SWRO Plant
24 MW
D&C Joint Venture
Suez‐Degrémont/
Multiplex/Worley
Parsons/Water Corporation
REFERENCES: UTILITY‐SCALE RENEWABLE POWERED DESALINATION – PERTH, AUSTRALIA
35
It is the first large‐scale seawater RO plant in
the world powered by renewable energy using
green electricity procured from an Australian
wind farm.
o The green electricity consumed by the
desalination plant is provided by the
80 MW Emu Downs Wind Farm.
o The wind farm comprises 48 wind turbines
and is located in a distance of 200 km from
the desalination plant.
Kwinana SWRO
Plant – Perth
Emu Downs
Wind Farm
General Information

o Seawater Reverse Osmosis (SWRO) is a feasible option to increase water availability for isolate
locations, cities, industrial applications or others
o Reverse Osmosis is the preferred technology for desalination
o If the SWRO plant uses the correct technology, the SWRO design will reduce energy consumption
and operational cost
CONCLUSION
o Energy renewable + SWRO are a good
match to reduce water cost, and
environmental impact
 Wind power
 Wave power
 DOE Announces Prize
Competition for Wave Energy
Water Desalination
 Solar Power
 Other options
37

4
20
4
1.3 1.3
0
10
20
30
Microwave oven TV plasma Space heater Water heater 3 tons ‐ AC
hours of operation equivalent to 6 kWh
SWRO energy consumption to produce water for a family of four for one day is equivalent to:
o 1 m3 of desalinated water requires 2.98 kwh
o 1 family of 4 persons – 100 gallons per person per day [1] – 400 gallons (1.5 m3) per family
 Equivalent to 4.5 kwh to produce desalinated water + 1.5 kwh for distribution
o 6 kwh is the same energy consumption for the following appliances [2]:
 Equivalent to 3 tons of air conditioning capacity running for 1.3 hour (covers 1,200‐
1,500 sf) [3]
CONCLUSION
38
Hours of Operation Equivalent to 6 kWh
[1]source: USCG, [2] Source: energy.gov, [3] Source: hvac.com

CONTACT US
39
Juan Miguel Pinto
+1.786.925.8500 | Office
+1.510.325.7412 | Mobile
jmpinto@energyrecovery.com
Energy Recovery, Inc.
1717 Doolittle Drive
San Leandro, CA 94577, USA
energyrecovery.com

�ճ󲹲԰��۴ǳ�

energy-recovery-presentation-2020-water-forum.pdf

�ݺ�ߣ

energy-recovery-presentation-2020-water-forum.pdf

More Related Content

energy-recovery-presentation-2020-water-forum.pdf