More Related Content
Similar to Basic Principle of Safety in minerals mining.ppt (20)
More from SlametSetyowibowo3 (8)
Recently uploaded (20)
Basic Principle of Safety in minerals mining.ppt
- 1. INTRODUCTION TO; PT. INCO BASIC SAFETY PREPARED BY M. Djufri. SD. E.H.S Department.
- 2. COMMITMENT PT. INCO ALL INJURIES CAN BE PREVENTED. THE ENVIRONMENT CAN BE PROTECTED EMPLOYEE INVOLVEMENT IS ESSENTIAL WORKING SAFELY IS A GOOD CONDITION OF EMPLOYMENT LINE MANAGEMENT IS RESPONSIBLE FOR PREVENTING INJURIESAND PROTECTING THE ENVIRONMENT. ALL OPERATING EXPOSURES CAN BE SAFEGUARDED TRAINING EMPLOYEES TO WORK SAFELY AND TO PROTECT THE ENVIRONMENT IS ESSENTIAL TO GOOD BUSINESS ALL OPERATING HAZARDS CAN BE SAFEGUARDED E.H.S Department.
- 3. SAFETY Semua upaya yang kita terapkan guna mengendalikan kerugian E.H.S Department.
- 4. Kecelakaan Suatu kejadian yang tidak diinginkan dan berakibat penderitaan manusia, kerusakan harta benda, atau kehilangan suatu proses. E.H.S Department.
- 5. Insiden Suatu kejadian yang tidak diinginkan, yang bila situasinya sedikit saja berbeda, sudah dapat mengakibatkan penderitaan bagi manusia, kerusakan atau terhentinya suatu proses. E.H.S Department.
- 6. E.H.S Department. 600 Rasio Kecelakaan 1 Fatal Serious Minor Incidents
- 7. Teori Domino Yang Diperbaharui Kendali Kurang Sebab Dasar Insiden Kerugian Sebab Langsung E.H.S Department.
- 8. E.H.S Department. SAFETY CONTRACTOR PROGRAM. The basic objective of PT. INCO Sorowako with respect to the Safety and Health of contractors employees is: To eliminate injuries and ill-health by continuously improving workplace practices and conditions It is our policy to ensure that every reasonable precaution is taken to prevent accidents. It is your accountability to act with due diligence in all work being performed. If you are not being duly diligent and accident occurs then you may well be prosecuted, convicted and fined under the occupational Health and Safety Act.
- 9. E.H.S Department. Accidents / Incidents. Unsafe conditions or practices must be reported to your supervisor immediately. Any injury, regardless of how slight, must be reported to your supervisor immediately. Your supervisor will direct you to a person who is trained to render first aid. Contractor supervisor and employees may be required to participate in an investigation of any incident or accident. The contractor shall ensure that accidents, injuries and near missincidents which could have resulted in injury or damage to property are reported to local PT. INCO management (sponsor) as soon as practicable.
- 10. Special Permit are ; 1. Permit to Work 2. Burning Permit 3. Site Clearance certificate. 4. Confined space entry permit. 5. Locking and Tagging Procedure PERMIT SISTEM. Is a rule to establish a uniform safe working practice and procedure to assure that equipment and area are safe to work on. The system consists of carrying out a procedure, obtaining special permits and permit to work. E.H.S Department.
- 11. E.H.S Department. Perlu ijin khusus Perlu ijin masuk tanki Perlu ijin menggunakan las listrik Perlu ijin Pembebasan Lokasi Perlu Switch Locking Procedurs Perlu ijin Kerja Laksanakan prosedur ijin masuk tangki Laksanakan Prosedur ijin mengelas listrik Laksanakan ijin Pembebasan lokasi Laksanakan Prosedur Penguncian Isi Formulir ijin bekerja Di Control Room Work Cordinator/ Planner W/O dari dept. ybs BEKERJA No No No No No Yes Yes Yes Yes Yes Yes No
- 12. Permit to work Is an authority issued by authorized employee and is an assurance that the appropriate precaution has been taken that it is safe to work on specified equipment subject to proper precaution being taken by the employee undertaking the work. EHS S.O.P No.020 - Rev.01 E.H.S Department.
- 13. Burning and Welding Permit Is an authority issued by the authorized department responsible for the area, and is assurance that necessary precaution has been taken to prevent predictable fire loss during welding or burning operation is being performed except in the areas classified as welding shop, or other areas declared by the department manager as such. Burning and Welding Burning and welding are not permitted unless fire protection is on site is provided by the contractor. Burning permits will be required for each working shift before commencing any burning and must be turned in to the appropriate INCO authority at the end of the shift E.H.S Department.
- 14. Site Clearance Certificate Is an assurance that the specified area are clear from underground installation or detailed warning to carry out excavation in a recommended manner because of the definite existence of underground installation IMPORTANT This clearance is not an assurance that other underground installation are perfectly void. The dead electrical-cable and underground piping may stay undetected. To eliminate the risk of damaging underground installation the engineering blue print has to be referred to as the main reference in issuing site clearance certificate, and has to be prepared by the work coordinator. As a standard practice there has to be warning strip laid and buried along the underground installations. E.H.S Department.
- 15. Confined Space Entry Permit. Is an authority issued by authorized employee skilled in gas detecting system and is assurance that the specified confined space is safe for entry. EHS S.O.P 020 - Rev. 01 速 Confined space is a space which by design has limited openings for entry and exit; has unfavorable natural ventilation which could contain or produce dangerous air contaminants, and which is not intended for continuous employee occupancy. 速 Each Department is to supply a list of confined spaces identified within their area responsibilities and to develop the safe working procedure how to make these confined space safety for entry. 速 The list of identified confined spaces, the pertinent information on the content during operation, the suspected contaminants that may exist, and the procedure to isolate the confined space must be provided. E.H.S Department.
- 16. Follow Standard PT INCO locking and tagging procedures obtain permission from PT. INCO to tag Sign log book and personal protection tag Authorized PT. INCO personnel will operate the switch and give you the only key. Attempt to field start the equipment Each work group must be removed at the end of each shift Personal tags (red) must be removed at the end of each shift Status tag must be installed to protect the equipment if work is not complete No one can remove another persons personal red protection tag All equipment must be locked and tagged out before working on it All sources of energy must be dissipated (ie. Air, water, hydraulic pressure), (Stopped, locked and tagged out prior to working on any equipment.) E.H.S Department. Locking and Tagging Procedure. Is a procedure that has to be carried out by authorized employee responsible for taking necessary precaution to protect himself and his party working on or near the specified equipment. EHS S.O.P 020 - Rev. 01
- 17. Scaffold Inspect before starting work No One allowed to ride on rolling scaffold Remove or secure equipment before moving Make sure handrail and midrail are rigidly secured Access to any area below must be restricted E.H.S Department.
- 18. Fall Protection Fall arrest condition is defined as a circumstances in which the work presents the potential that a free fall may occur. A fall arrest protection system is then required that stops and suspends a person in the event of a free fall. Travel Restrain Condition is defined as a circumstances in which the work places the worker within 2 meters (6 feet) of a fall hazard. A travel restrain protection system is required that prevents a person from approaching the fall hazard thus eliminating the potential for a free fall Fall Arrest System consist of a full body harness, shock absorber, a lanyard and an anchor point Travel Restrain System is to be used when a person is working within 2 meters (6 feet) of an open Hole. It consists of a safety belt, a lanyard and an anchor point. E.H.S Department.
- 19. Fire Procedures Be familiar with local plant fire procedures If a fire occurs, extinguisher or hose is used for any reason. Local PT. INCO management must be notified in writing using the approved form. Contractors must provide and maintain fire protection for the work site Burning rubbish will not permitted on site Approval must me obtained before any connections are made to company fire hydrants or water lines. E.H.S Department.
- 20. Contractors must obey all road signs Speed limit in the plants is 30 km/hr. unless otherwise posted Pedestrians have the right of way at all crosswalks Seat belts are to be worn by all personnel in a motor vehicle Seat belts are to be worn on all ROPS equipped vehicles Operators are responsible for the safe operation of their vehicle. Transportation and Traffic E.H.S Department.
- 21. All Injuries must be reported Phone Fire & Rescue for Assistance Telephone No; 2224, 81, 82 OR P.T.I Radio Channel 1 or ORARI Freq. 145.000. (call sign Siera Base) E.H.S Department.